Now possible to configure Checker to boot using the currently running job.

In Checker version 2.6, you can configure Checker to restart using whatever job was running when Checker was power cycled. This replaces the previous behavior where Checker ran the job that was running when you entered Run mode. This change means that you can guarantee that Checker will be running the same job after a power cycle or reboot, even if Checker has received one or more job change signals since entering Run mode. As with earlier Checker versions, Checker version 2.6 also allows you to specify a specific job by name; this functionality is unchanged in version 2.6.

Microsoft Windows 7 now supported

Checker version 2.6 adds support for the Microsoft Windows 7 operating system (32-bit only). Checker version 2.6 continues to support Microsoft Windows 2000? SP4, Windows XP?, and Windows Vista?.

Downloads:

     

Cognex Checker software V2.6     (177MB)

      

Sensorviewer firmware V2.6          ( 27MB)

       

Voor meer informatie vragen wij u contact op te nemen met onze product specialisten